[OPINION] Civil plutonium can be used to make effective nuclear weapons
Scitizen.comCan the plutonium recovered from spent civil nuclear-power reactor fuel elements (civil plutonium) be used to fabricate nuclear weapons with significant explosive powers?
This question has been the subject of much discussion since the end of the Second World War. President Dwight Eisenhower’s Atoms for Peace initiative, spread American nuclear knowledge and materials far and wide, apparently on the belief that civil plutonium from power reactors was unsuitable for use in nuclear weapons. The belief that civil and military plutonium could be safely separated was inherent in the negotiation of the Nuclear Non-Proliferation Treaty (NPT) in 1967.
The plutonium produced in nuclear-power reactors operated for the most efficient generation of electricity, called reactor-grade plutonium, contains a higher proportion of the isotope plutonium-240 than that preferred by nuclear-weapon designers. Typical reactor-grade plutonium contains 1.3 per cent plutonium-238, 56.6 per cent of plutonium-239, 23.2 per cent of plutonium-240, 13.9 per cent plutonium-241, and 4.9 per cent plutonium-242. Nuclear-weapon designers prefer plutonium containing, typically, 0.012 per cent of plutonium-238, 93.8 per cent of plutonium-239, 5.8 per cent of plutonium-240, 0.35 per cent of plutonium-241, and 0.022 per cent of plutonium-242, called weapon-grade plutonium. The major difference is that weapon-grade plutonium is richer in plutonium-239 and poorer in plutonium-240 than weapon-grade plutonium.
As J.Carson Mark explained there are two major problems with using reactor-grade plutonium in a nuclear weapon (1). Mark is undoubtedly an expert on the subject. He headed the Theoretical Division at the US Los Alamos National Laboratory for decades; was intimately involved in the design of both nuclear fission weapons and thermonuclear weapons.
The first problem is that plutonium-240 has a high rate of spontaneous fission so that the device will continually produce many neutrons. One of these background neutrons may set off the fission chain reaction prematurely, called pre-initiation, causing the device to have a relatively low explosive yield. The spontaneous emission rate of reactor-grade plutonium is about 360 neutrons/second/gram. The figure for weapon-grade plutonium is about 66 neutrons/second/gram. The probability of pre-initiation using reactor-grade plutonium is, therefore, much larger.
The second problem described by Mark is the heat produced by the alpha-particle decay of plutonium-238. The amount of plutonium-238 in reactor-grade plutonium is about one or two per cent. This contributes 10.5 watts of heat per kilogram of reactor-grade plutonium, compared with 2.3 watts per kilogram of weapons-grade plutonium. The design of a primitive nuclear explosive using reactor-grade plutonium would have to incorporate a method of dispersing the heat – such as the use of aluminium shunts. Otherwise, the plutonium would get very hot and become distorted or even melt.
Mark explained that, in spite of these problems, nuclear weapons could be fabricated using reactor-grade plutonium. “The difficulties of developing an effective design of the most straightforward type is not appreciably greater with reactor-grade plutonium than those that have to be met for the use of weapons-grade plutonium”.
More reactor-grade plutonium than weapon-grade plutonium would be required for a nuclear weapon. The bare sphere critical mass of reactor-grade plutonium is about 13 kilograms; that of weapons-grade plutonium is 10 kilograms.
Mark’s analysis was supported by Richard L. Garwin, another leading American nuclear-weapon expert expert, who wrote that reactor-grade plutonium is usable in nuclear weapons, whether by unsophisticated proliferators or by advanced nuclear-weapon states (2). Garwin was a consultant for the Los Alamos National Laboratory from 1950 to 1993, mostly involved with nuclear weapon design,manufacture and testing.
He was an author of the report by the Committee on International Security and Arms Control of the US National Academy of Sciences that concluded: “In short, it would be quite possible for a potential proliferator to make a nuclear explosive from reactor-grade plutonium using a simple design that would be assured of having a yield in the range of one to few kilotons, and more using an advanced design”. (3).
At a conference at the International Atomic Energy Agency in June 1997, Matthew Bunn, of Harvard University, discussed the value of reactor-grade plutonium for the fabrication of nuclear weapons, stating that countries with advanced technologies "could, if they chose to do so, make bombs with reactor-grade plutonium with yield, weight, and reliability characteristics similar to those made from weapon-grade plutonium”. He went on to point out that “in some respects if would actually be easier to make a bomb from reactor-grade plutonium (as no neutron generator would be required)" (4).
A detailed description of the nuclear physics involved in the design of nuclear weapons was given by Amory B. Lovins in the British scientific journal Nature in 1980 (5). It gives the physical basis for understanding the scope for using reactor-grade plutonium in nuclear-fission weapons and shows that plutonium from nuclear-power reactors “can produce powerful and predictable nuclear explosions”.
In 1953, the British exploded a nuclear weapon at the nuclear test site in South Australia made from plutonium of a quality considerably below that of weapons-grade (6). In 1962, the United States conducted a similar nuclear-weapon test (7). The actual amount of Pu-239 in the plutonium used in these tests has not been made public but it was apparently about 19 per cent. The tests were made to prove that reactor-grade plutonium can be used in an effective nuclear weapon.
Given all this evidence, it is, to say the least, surprising that some people still deny that reactor-grade plutonium can be used to fabricate nuclear weapons with significant explosive powers?
References
1. J. Carson Mark, Explosive Properties of Reactor-Grade Plutonium, Science and Global Security, Vol.4, pp.111-128, 1993.
2. Richard L. Garwin, Reactor-Grade Plutonium Can be Used to Make Powerful and Reliable Nuclear Weapons: Separated plutonium in the fuel cycle must be protected as if it were nuclear weapons, Federation of American Scientists, August 26, 1998.
www.fas.org/rlg/980826-pu.htm
3. Committee on International Security and Arms Control (CISAC) of the National Academy of Sciences, The Management and Disposition of Excess Weapons Plutonium, National Academy Press, Washington, DC (1994), pp32-33,
text is available at
http://www.nap.edu/readingroom/enter2.cgi?0309050421.html
See also:
American Nuclear Society, Protection and Management of Plutonium, Special Panel Report, August 1995, p. 25.
4. Bunn, M, The US Program for Disposition of Excess Weapons Plutonium, Paper to International Atomic Energy Agency Conference, Vienna, June 1997.
5. Lovins, A. B., "Nuclear Weapons and Power-Reactor Plutonium", Nature, 28 February 1980, pp.817-823 and typographical corrections, 13 March 1980, p.190.
6. Arnold L., ‘A Very Special Relationship: British Atomic Weapon Tests’, Chapter 4, HMSO.
7. U.S. Department of Energy, Additional Information Concerning Underground Nuclear Weapon Test of Reactor-Grade Plutonium, Office of the Press Secretary, Washington, DC apollo.osti.gov/html/osti/opennet/document/press/pc29.html
Wow, is this ever old news. 40+ years old to be precise. This is why the IAEA controls all plutonium, reactor and weapons grades, and has since the early 60s.
ReplyDeleteNothing new to see here, let's quickly move on to the next story about LANS' ineptness.
Nuclear terrorism, most risky, post 9/11/01:
ReplyDelete(1) HEU bomb.
(2) RDD ("dirty bomb").
(3) A stolen nuclear weapon.
(4) Nuclear terrorism manufacturing of their own nuclear weapons, either with HEU, weapon-grade plutonium, and reactor-grade plutonium is less likely than (1) - (3) to occur.
It also depends on the reactor design and how high the "burnup" of the fuel is. The higher the burnup, the less the ability to make that fuel into a nuclear weapon.
ReplyDeleteIn the case of a reactor like Argonne National Laboratory's IFR - Integral Fast Reactor; it is impossible to make the spent IFR fuel into a nuclear weapon.
http://www.pbs.org/wgbh/pages/frontline/
shows/reaction/interviews/till.html
"It's impossible to handle for weapons, as it stands. It's highly radioactive. It's highly heat producing. It has all of the characteristics that make it extremely, well, make it impossible for someone to make a weapon."
This was confirmed by scientists at Lawrence Livermore as Senators Simon and Kempthorne write in their letter to the New York Times in 1994:
http://query.nytimes.com/gst/fullpage.
html?res=9B05E4D91E3CF936A35754C0A9629
58260
"A recent Lawrence Livermore National Laboratory study indicates that fuel from this reactor is more proliferation-resistant than spent commercial fuel, which also contains plutonium."
I was thinking the same thing 7:35 pm. Old news.
ReplyDelete